E6X EKP To Fuel Pump Wiring Harness

E6X EKP To Fuel Pump Wiring HarnessOur upgraded EKP module to fuel pump wiring harnesses are made with high quality 12 AWG Cross Link TXL wire. The wiring is rated for a peak current of 25A and has a thermal rating of 40C to 125C. These specs ensure that your fuel pump will receive all of the power that it demands! The harness also uses OEM style connectors to make this installation as easy as possible! Each harness is hand made in house by Arc Terminator. Installation instructions are

Please visit our Warranty Policy page at the following link for more information: https://arcterminator

7' F03 LCI   (03/2012 — 06/2013)

There are two versions of the kit

A: Absolutely

Our upgraded EKMP3's offer a 22 Amp INCREASE in maximum current capacity over an OEM EKPM3

Q: Why is a relay used instead of just tapping into the wires coming out of the EKP to the fuel pump like I've seen in other DIY's

6' E63 LCI   (04/2006 — 07/2010)

you may receive heatsinks that look different than what is pictured

as a material for all of my prints

which may prevent the heatsinks from adhering properly

We also offer a DIY kit that includes everything you'll need to create your own active cooling solution here: https://arcterminator

we will remove the factory half bridge IC