Garage door draught excluder sealing strip. 15mm long brush, 2 at 1100mm.

Garage door draught excluder sealing strip. 15mm long brush, 2 at 1100mm.We supply this part in 2 off pieces at 1100 mm to cut in to your size door maximum 2200 mm or 7 foot 2 inches long so the item can be couriered by "myhermes" to most UK postcodes including NI, but excluding Scottish isles and channel islands. A 7 foot 2 inches length split into 2 parts (as above) kit, this is to get it sent by myhermes. Please allow 3 days to despatch and 3 to 4 working days to deliver i. e. 5 7 working days to delivery, we have a lot

To fit and or

cockroaches yes they are in the UK aluminium

Undrilled for you to add holes where you need them not where we guess

MILL ALUMINIUM (NOT LIGHT DIY)

ATT GEORGE CULLEY'S:-

if you need a size please ask if

PLEASE ASK FOR RATE

good for anti -slamming device on doors

Up to 2100 mm high x 1050 mm wide

50 mm size is for fine draught proofing from 0 – 48 mm gaps

the trim of brush is 50 mm out of the steel backing inside the aluminium on this sizing giving about 48 mm of bristle out of the aluminium holder

This product (subject to sizing (below) will fit down the bottom of an up and over garage door) with this kit it will seal from 1800 mm up to 2400 mm