Arning Template (Shelby Drop) for 1967 - 1973 Mustang (with 17/32" Drill Bit)

Arning Template (Shelby Drop) for 1967 - 1973 Mustang (with 17/32" Drill Bit)This template known as the Arning Drop, Shelby Mod, or Shelby Drop is designed to work with the 1967 1973 Mustang and it relocates the mounting point for the Upper Control Arm to provide a better roll center, a small bump in negative camber, and a little more positive caster for these cars. This template is designed to be used on both the driver passenger side, with the arrow cut in the template pointing towards the front of the car when in use.

Tighten the two nuts to your desired location to ensure proper parking brake engagement

You will need to reuse the existing nuts that secured your seats to the car for these extension pieces when you install them back into your car

the Brake Master Cylinder Support

but the concept and instructions are basically the same

so I designed these caps to be a low profile option

The self-tapping screws use a 5/16" socket

and the Brake Master Cylinder Support

and there's 3 different pocket depths to choose from to best fit your vehicle

This Fuel Pressure Gauge kit is designed to work with fuel lines that have a -6AN fitting as it sits between the fuel line from the fuel pump to the fuel inlet line on the Carb

This can lead to premature stresses on the pulley and can cause failure of the pulley at the mounting surface

so the suspension can work more precisely

The video for the install is for the 1964-1968 Mustang