Milling arbors for screw-in cutters BT 50 - M10 - 88 - LB50

Milling arbors for screw-in cutters BT 50 - M10 - 88 - LB50Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For cleaning internal tapers on machine spindles

20mm for over 500mm/20" range

4 and 5 mm only solid carbide tool shanks must be used

- Calibration of the angular position of spindles of milling-turning centres

Individual serial numbers on each block

Water and dust resistant design

For sealing tools with internal cooling in collet chucks

LSCX = Clamping depth

Instructions for useWrench4 pcs

Bed height H: 0

minimum and diviation

Clamping force preadjustable by graduation lines