Simplex 4098-9714

Simplex 4098-9714TrueAlarm photoelectric sensors use a stable, pulsed LED light source and a silicon photodiode receiver to deliver consistent and accurate low power smoke sensing. Three user selectable sensitivities for special applications are available for each individual sensor, 0. 2%, 0. 5%, and 1% per foot. Standard sensitivity is 1. 25% to 3. 1% per foot. The fire alarm control panel runs an algorithm that can vary the sensitivity for normal applications

The module mounts to the main board on the J8 option connector

It can also be used in retrofit applications powered by any UL-listed regulated 24 V DC supply

Type: Replacement Glass Rod

The IP communicator’s internet monitoring capability sends alarm signals over the Internet saving the monthly cost of two dedicated business telephone lines

If this applies to you

Its steel enclosure has room for up to two 24 ampere-hour batteries

The Model DS-SD Duct Smoke Detector detects the presence of smoke under extended temperature ranges in a building’s HVAC system

The FACP identifies the alarm point on the polling circuit and the alarm lever latches in the pulled position

72" high x 3

Simplex fire alarm networks communicate information among distributed Simplex fire alarm panels

Description

and many additional options