Transmitter Power Supply KFU8-CRG2-1.D

Transmitter Power Supply KFU8-CRG2-1.DKFU8 CRG2 1. D, Transmitter Power Supply 1 channel signal conditioner Universal usage at different power supplies Input 2 wire and 3 wire transmitters and 2 wire current sources Output 0 4 mA 20 mA 2 relay contact outputs Adjustable energized de energized delay Programmable high low alarm Linearization function (max 20 points) Line fault detection (LFD) Up to SIL 2 acc. to IEC EN 61508 IEC EN 61511 This signal conditioner provides galvanic isolation

The module reads the variables from the instrument and converts these to  dynamic variables on PA

[Ex ia Ma] I General information Supplementary information Observe the certificates

30 V DC / 90

Plugs directly in to field side of KF modules

The temperature sensor detects the skin temperature at the inlet of the steam trap and is displayed as SV

In the event of a device fault or a wiring fault of any isolator on the Power Rail

Depending on the application

[Ex ia Ma] I General information Supplementary Information Observe the certificates

Via switch the function of the second output can be defined as a signal output or an error output

4 V Current Io 115 mA Power Po 584 mW Equipment terminals 5-

the relay reverts to its de-energized state and the LEDs indicate the fault

Programmable high/low alarm