Clevite 1980-1996 Chevrolet C3-C4 Corvette Tri Armor Pass & Trk 366/396/402/427/454 Main Bearing Set

Clevite 1980-1996 Chevrolet C3-C4 Corvette Tri Armor Pass & Trk 366/396/402/427/454 Main Bearing SetClevite H Series performance bearings have a medium level of eccentricity, high crush, and a hardened steel back and thin overlay. These bearings are made without flash plating for better seating. Use H Series bearings with crankshafts that have oversize fillets and where engines run in the medium to high RPM range. This Part Fits: Year Make Model Submodel 1995 1996 AM General Hummer Base 1980 1985,1987 1990 Avanti II Base 1985 Avanti II GT 1980 Buick

Please allow 1-2 weeks for shipment

Restore your 1970 C3 Corvette interior with these correct Green Rear Door Pulls from Auto Accessories of America

Featuring an all-over sublimated Bowtie design

• Patent Pending Velcro® Design for rearview mirror & rain sensors• Silver exterior color reflects the sun and UV• Black interior color blocks light and can be reversed for winter use • Compact Storage – fits in the door pocket or between car seats• Center fabric keeps light out unlike inexpensive 2-piece sunshades• Velcro center with sun visors down ensures your sun shade will stay up• 3-year limited replacement warranty*Installing your OC Sun Shade• Remove the OC Sun Shade (herein OCSS) from the packaging• Unfold your OCSS and keep the Velcro® center area at the top• Slide the bottom of the OCSS in toward the bottom of your windshield• Note: Silver Side should face OUT (black on the inside) to reflect heat & UV away from your car• Separate the Velcro® and spread the two sides around your rearview mirror area• Reconnect the Velcro® to help keep out sunlight around your rearview mirror area• Fold down both sun visors to help keep your OCSS up and keep out sunlight at the top of your windshield• Adjust the center fabric area and sides of the round sections of the OCSS as neededFolding your OC Sun Shade• Fold your OCSS in half with the two black sides facing each other• Position the elastic at 6 o’clock position• Place your hands at the 3 and 9 o’clock positions• Twist the sunshade and fold in half• Then use the elastic to pull over the sunshade to keep it tight and compact

7") and 12mm ball joint studs Length is measured from the center of one ball joint stud to the center of the other

Developed using latest FEA and CAD software

Converts single-bolt LS engines to 3-bolts configuration

Will only fit Z06 model with Stage 1 or Stage 2 wing

Part Type: Front Air Dam (Stock Fitment)

A traditional design and shape

Installs over factory cap with included 3M automotive double-sided tape

this Quiet-Ride Compartment Divider - Z06 405HP - CA ensures an exceptional fit and outstanding performance