Hub Wrenches

Hub WrenchesThis tool set is required to disassemble or tighten the three piece front hubs found on most Pre War cars. Before ordering look inside the front hubs after they have been removed from the spindle and have had their bearings removed. If you see an interior nut with four face spanner holes this tool set will be required. If the hub is one piece this tool is not required. No dis assembly is possible. Part No. MP 104 120

Contact the storekeeper at storekeeper@silverghostassociation

Order quickly

ISO 1000 steam cylinder oil is used for the base stock as the moly additive reduces the viscosity a little

SGA-16 for large

you could have trouble

Because the Lovejoy shock absorber fluid level is above the shaft elevation

It allows the use of plain water without antifreeze and extends the life of IAT antifreeze to five years

Hint:  Adjusting the mag points to a minimum opening gap really helps the mag life

Light and License Plate PanelStamped 11 gauge mirror finish stainless steel panel that resembles German silver

Capable of continuous duty so it can run a mag for hours just as it would if the unit was on the road providing ignition to the engine

These will help you get the threads back right again

As you might imagine